Washer & Dryer Repair

washer dryer controls

(575) 221-5562

One of the worst appliance-related inconveniences is when your dryer or washer quits working. No one has time to run back and forth to the laundromat and you can only ignore the piles of dirty clothes for just so long. You need to contact a reliable and affordable company, like Las Cruces Appliance Repair, that offers same-day washer and dryer repairs.

Our repairmen have years of experience, continual training and the correct parts and tools to do both basic and complicated repairs on a single visit. Our vans are always stocked with the parts and tools needed to fix GE, LG, Armstrong, Goodman, Lennox, Kenmore, Bryant, Carrier, RCA, Sears, and all other major brands!



The most frequent reason we visit to fix a washer is that it is making a lot of noise. These are important service calls because the source of the loud noise will next become the reason that our washer does not work at all. Broken bearings, worn belts, and damaged water pumps are the usual reasons for the racket.


Whenever the washing machine does not turn on, check the circuit breaker and make sure the appliance is plugged in. If you need to call us, we can come the same day. When the washer will not turn on, you typically have a bad timer, burned out thermal fuse, or a broken door latch. When the washer will not agitate the transmission is not working, the coupler is broken, the drive belt has worn out, or the agitator cogs are damaged. We will find the cause and fix or replace parts as needed, all on the day that you call us for help.


When the washer does not spin, the problem is a non-functional wax motor, broken door latch, or damaged motor coupling. We can fix these problems on the spot when you call us for repair services.


When your washer overflows, mop up the mess and then call us. You have a problem with the air dome tube, a water level pressure switch, or the water inlet valve. We will be glad to fix or replace the offending part on the spot.


Your washer needs to have both hot and cold water to do its job. When the temperature control switch is broken or the inlet hose is blocked you have a hot or cold water issue. Call us for same-day repairs.



The most frequent reason we repair dryers is that they are making a loud noise. This usually happens because of a worn belt, a damaged seal, or a broken bearing. Call us for help before the dryer breaks down!


When your dryer will not heat up, it has a problem with the cycling thermostat or high limit thermostat, or the heating element is broken. And, depending on just how these parts malfunction, they may cause the dryer to get too hot as well! Our certified technicians can check out the problem and fix it on a short service visit.


Make sure that your dryer is plugged in and that the circuit breaker is on in cases where the appliance will not start. If you have to call us, the trouble is usually a broken heating element or trouble with either the high limit thermostat or cycling thermostat. These can be repaired or replaced with manufacturer parts the same day that schedule a service call.


When dryer refuses to turn off, it has a broken timer or damaged door switch. Don’t get into the habit of just unplugging the appliance. Call us for a same-day fix.


When the timer on our dryer does not advance properly, the dryer will not complete its cycle. Damaged timing motors and broken cycling thermostats are usually at fault in this case. Call us to fix the problem on the spot.